IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 117 / 168

1
From the OPCON prompt, which is an asterisk (*), type talk 6 and press
Enter. The
Config
>
prompt appears.
2
Type boot and press Enter. The Boot config
>
prompt is displayed.
3
To get the MAS software code load:
¹
Enter t f t p get load modules (for MAS software Version 2 or above)
¹
Enter t f t p get load single image (below MAS software Version 2).
To get a configuration file, enter tftp get config
You cannot overwrite a currently active bank image.
4
When prompted, specify the IP address of the TFTP server.
5
When prompted:
¹
Specify the path/file name for a single image
or
¹
Specify just the path for load modules
With Version 2, when you specify that you want load modules to transfer, all
of the appropriate load modules in the specified directory will be transferred.
There could be up to 20 separate load modules. All the load modules must
be in the same directory to enable the successful transfer of all the modules.
The following example shows a Version 2 software code load:
* talk 6
Config> boot
Boot config> tftp get load modules
Specify the server IP address (dotted decimal): [1.2.3.4] 192.9.200.1
Specify the remote files directory: :(/u/bin/) /usr/601bin/204img/
Select the destination bank: (A,B): [A] a
TFTP SW load image
get: /usr/601bin/204img/LML.ld
from: 192.9.200.1
to: bank A.
Operation completed successfully.
TFTP File Transfer using the Firmware
1
From the main firmware menu (“Systems Management Services,” select (4.
utilities)
2
From the “Systems Management Utilities” menu select (12. Change
Management).
3
From the “Change Management Software Control” menu select (10. TFTP
software).
Note: You must have setup your IP addresses on the devices before you
can TFTP. (See section “Setting Up Remote Initial Program Load” on
page 4-19 to setup IP parameters in the firmware.)
4
Select the type of software from the “Select Type” dialog box.
Appendix D. Managing Operational Code and Configuration Files
D-3