IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 47 / 168

✹
✹
✹
✹
OK
Wrong
Slot
When the card makes full contact with the rear of the IBM 2216, press and simultaneously turn each
thumbscrew on the face of the adapter card clockwise,
only until the adapter is firmly seated.
10
Secure the module by tightening the screws.
11
Check that the green LED of the adapter comes ON and that the Wrong Slot LED is OFF. If not,
check the adapter installation. If the problem persists call the support center. Otherwise, continue.
12
If you are replacing/inserting a serial adapter (EIA 232E/V.24, V.35/V.36, X.21, which are LICs 282,
290 and 291) and you went through the WAN Reroute disable procedure (“Disabling Interfaces that
Have WAN Reroute Enabled” on page F-8), you need to enable the WAN Reroute process. (See
“Enabling WAN Reroute after You Have Disabled it” on page F-9).
13
Replace the removed cable or cables, then tighten the cable screws (if present).
14
Re-enable all adapter ports. See “Resume Traffic on an Adapter Port” on page F-7.
Chapter 2. Removal and Replacement Procedures
2-17