IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 87 / 168

‡@ —
Device List
"For more information on each device select from the following list:
Device Location Status
Token Ring Slot 1 Multi-Port Adapter ENABLED
< 1. Token Ring> Slot 1 Port 1 Net # 0 ENABLED
Token Ring Slot 1 Port 2 NOT CONFIGURED
< 2. ATM MMF > Slot 2 Port 1 Net # 1 DISABLED
< 3. ESCON > Slot 3 Single Port Net # 2 ENABLED
< 4. ESCON > Slot 4 Single Port -- NOT CONFIGURED
Some of the devices are note currently available for testing. This can occur
when a test is not available for the device or when the device must be
configured in order to be tested,
Select (1-4 or D=Down B=Back R=Refresh h=Help):
ˆ ˜
Figure 5-2. Sample of Device List Panel Showing Interfaces
The Device List is the starting point for running a test. It also provides a
check to determine if all of the installed devices are being recognized by the
2216.
The Device List includes a summary status for each device. The devices
that are testable or that have additional status available can be selected.
Selecting a device will then display the Device Status and Control page for
that device.
The Status displayed for a device may have the following values:
ENABLED Device is enabled for normal operation. For
multi-port devices this means that at least one port is
enabled.
ENABLE PENDING Waiting for completion of Enable request.
Special Device is in a special state that is explained on the
Device Status and Control Page.
DISABLED Device is Disabled. Diagnostic testing can now be
performed. For multi-port Devices this means that
all ports are disabled.
DISABLE PENDING Waiting for completion of Disable request.
MESSAGE Select the device to view and respond to the
message.
TESTING The device is being tested.
NOT CONFIGURED The device is not configured for normal operation.
MIS CONFIGURED The configuration does not match the physical
device.
HARDWARE ERROR A Hardware Error has been detected which prevents
further use of the device.
Chapter 5. Using Operational Diagnostics
5-3