IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 136 / 168

5
Dial in to the 2216’s PCMCIA modem with a TTY console. The
console settings must be:
Speed = 19200 bps
Data bits = 8
Parity = No
Stop bits = 1
6
Once the connection is established, type in the password and
press Enter. The password will not be displayed, but you should
get an * on your screen for every character that you enter.
7
Press F1 to terminate the boot sequence and enter the firmware
Systems Management Services menu.
8
Select 4. Utilities from the Systems Management Services menu.
9
Select 12. Change Management from the Systems Management
Utilities menu.
10
For MODEM: Configuration file must be on remote console, but no
IP addresses are needed.
a. Select 12. Xmodem software from the Change Management
Software Control menu.
b. Select 1. Config from the Select Type dialog box.
c. Select the Bank to send the configuration file to from the
Select Bank dialog box.
d. Select the config # to send the configuration file to from the
Select Config dialog box.
e. When the BEGIN FILE TRANSFER dialog box closes, use
your Xmodem software to transfer the files. For example, with
PROCOMM:
-Press the PAGE UP key when the dialog box disappears.
-Press X for xmodem mode.
-Type in the path and file name of the configuration
you are going to transfer to the 2216.
-Press ENTER.
11
For TFTP: You must have a PCMCIA networking card in the
PCMCIA slot before booting the 2216 and be connected to a
network that has the configuration file you are going to transfer to
the 2216.
Note: IP addresses need to be set up on the PCMCIA slot using
the System Management Utilities menu and select 11. Remote
Initial Program Load Setup before a TFTP can be done.
a. Select 10. TFTP software from the Change Management
Software Control menu.
b. Select 1. Config from the Select Type dialog box.
c. Select the Bank to send the configuration file to from the
Select Bank dialog box.
F-10
2216 Maintenance Manual