IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 67 / 168

Selecting a Device To Test
Extensive hardware tests are performed by the firmware when the IBM 2216 boots
up. But there may be times when you have removed and replaced a failing part
and you want to run an individual test before a full bootup or reset. The firmware
allows you to run these individual tests:
¹
Test All Subsystems: This test runs all the subsystem tests that are listed on
this panel.
¹
Test Memory: This test searches all available memory regions, tests the
regions, and presents a consolidated list of test results.
¹
Test System Board: This tests the PowerPC CPU, the System Board interrupts,
and the PCMCIA controller.
1
Select 3. Select Device to Test from the main menu.
2
The Select Device to Test panel is displayed (Figure 4-5).
Note: The Select Device to Test panel is created dynamically, depending on
what diagnostics have been loaded, but the items shown always appear.
‡@ —
Nways System Firmware
Version 1.0
(C) Copyright IBM Corporation, 1996 All Rights Reserved.
System Management Services
Select one:
1. Manage Configuration
2. Boot Se---------------Select Device to Test----------------+
3. Select Device |
Esc=Quit -|
4. Utilities | ----------------|
| F1=Help -|
| ----------------|
| {>} Test All Subsystems Spacebar=Choose -|
| { } Test Memory ----------------|
| { } Test System Board F4=Parm Setup -|
| { } Test IDE devices ----------------|
| F6=Execute -|
| ----------------|
| F9=Display Error Log -|
Enter - | ----------------|
---------- | |
+----------------------------------------------------+
ˆ ˜
Figure 4-5. Test Selection Panel
3
Use the spacebar and up arrow and down arrow keys to select the test.
4
Press F4 to define additional test parameters.
Note: Errors encountered during diagnostics are logged in the hardware
error log.
5
Press F6 to start a test.
6
After the test is complete, press Esc to return to the main menu panel.
Chapter 4. Using 2216 Firmware
4-7