IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 71 / 168

Enabling Unattended Start Mode
The default is that Unattended start mode is enabled. This causes the IBM 2216 to
load operational code automatically.
This function can be performed only if done immediately after switching the power
on.
1
Select 3. Enable Unattended Start Mode from the utilities panel. The
Unattended Start Mode Changed panel is displayed (Figure 4-9).
2
Press Enter.
‡@ —
Nways System Firmware
Version 1.0
(C) Copyright IBM Corporation, 1996 All Rights Reserved.
System Management Utilities
Select one:
1. Set Power-On Password
2. Set Sup------Unattended Start Mode Changed-------+
3. Enable Unatten|
|
4. Disable Unatte| Unattended start mode has been |
5. Remove Power-O| enabled. |
6. Remove Supervi| |
7. Update System | Enter - |
8. Display Error | --------- |
9. View or Set Vi+------------------------------------------+
10. Manipulate Dead Man Timer
11. Remote Initial Program Load Setup
12. Change Management
13. Prepare Hard Disk
Enter - Esc=Quit - F1=Help -
----------- -------------- -------------
ˆ ˜
Figure 4-9. Unattended Start Mode Changed (Enabled) Panel
Note: After you have enabled Unattended start mode, you can enter the firmware
by pressing and holding F1 at the terminal keyboard when the boot process begins.
Chapter 4. Using 2216 Firmware
4-11