IBM eServer 342 xSeries, Руководство пользователя

Страница: 99 / 160

Chapter 6. Solving problems
85
POST error messages
The following tables provide information about the POST error messages that can
appear during POST.
Note: Refer to the User’s Reference on the IBM xSeries Documentation CD for more
detailed information about POST error messages.
POST message Description
062 The server failed to boot on three consecutive attempts.
All caches are disabled. Repeatedly turning the server on and then off or resetting the server
might cause this problem.
Action: Start the Configuration/Setup Utility program and verify that all settings are correct.
Use the
Cache Control selection in the Advanced Setup menu of the
Configuration/Setup Utility program to enable the caches.
If the problem remains, call for service. When the problem is corrected, be sure to enable the
caches.
101 102 106 An error occurred during the system board and microprocessor test.
Action: Call for service.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove the options. If you can start the server without the options installed, reinstall
each option one at a time and retest after each is reinstalled. When an option fails,
replace it.
If you cannot isolate and correct the problem, call for service.
129 An error was detected in the L1 cache of one of the microprocessors.
Action: 1. If you just installed a microprocessor, verify that the microprocessor is installed
and seated correctly.
2. If the problem remains, call for service.
151 A real-time clock (RTC) error occurred.
Action: Call for service.
161 The real-time clock battery has failed.
Action: Replace the battery yourself or call for service.
You can use the server until you replace the battery. However, you must run the
Configuration/Setup Utility program and set the time and date and other custom settings each
time you turn on the server.
Table 13. POST error messages.