IBM eServer 342 xSeries, Руководство пользователя

Страница: 65 / 160

Chapter 5. Installing Options
51
To install a drive in a hot-swap drive bay:
1. Review the information in “Before you begin” on page 35 and “Handling static-
sensitive devices” on page 36.
Attention: To maintain proper system cooling, do not operate the server for more
than two minutes without either a drive or a filler panel installed for each bay.
2. Remove the filler panel from one of the empty hot-swap bays by inserting your
finger into the depression on the filler panel and pulling it away from the server.
3. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (that is, perpendicular to the drive).
b. Align the drive/tray assembly with the guide rails in the bay.
c. Gently push the drive/tray assembly into the bay until the drive touches the
backplane.
d. Push the tray handle down until it locks.
4. Check the hard disk drive status indicators to verify that the hard disk drive is
operating properly. (See “Server controls and indicators” on page 5 for the
location of the status indicators.)
• If the amber light is on continuously, the drive has failed.
• When the amber light flashes slowly (one flash per second), the drive is being
rebuilt. (This occurs only if you have a RAID adapter installed.)
• When the amber light flashes rapidly (three flashes per second), the controller
is identifying the drive. (This occurs only if you have a RAID adapter
installed.)
• The green activity light flashes when there is activity on the drive.