IBM eServer 342 xSeries, Руководство пользователя

Страница: 74 / 160

60
IBM xSeries 342: User’s Reference
4. Remove the air baffle by grasping it at the sides and lifting it from the server.
5. Remove the terminator card from the microprocessor connector by lifting the
release arm on the carrier. Leave the lever in its open position.
6. Store the terminator card in a safe place in the static-protective package that your
new microprocessor comes in; you will need to install it again, if you ever remove
the microprocessor and do not replace it.
7. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to
any
unpainted metal surface on the server; then, remove the microprocessor
from the package.
b. Line up the microprocessor pins over the microprocessor connector and
carefully press the microprocessor into the connector.
c. Press down and latch the release lever.
Note: To remove a microprocessor, pull upward on the microprocessor release
arm and then lift the microprocessor out of the connector.
8. Install the voltage regulator module (VRM) included in the microprocessor kit.
Attention: When installing or replacing a VRM, use only a VRM specified for use
with the xSeries 342 server. Use of other VRMs might cause your server to
overheat.
a. Center the VRM over the VRM connector. Make sure that the VRM is oriented
and aligned correctly.
b. Press the VRM into the connector.
Note: If you remove the microprocessor later, remember to install the terminator
card in the appropriate microprocessor connector and to remove the VRM.
9. Remove the thermal tape liner from the underside of the fan sink and discard.
10. Set the fan sink into place.
Microprocessor 2
Fan sink
(Remove thermal tape liner on installation)
Microprocessor 1 location
VRM 1
Terminator card
VRM 2
VRM connector