IBM eServer 342 xSeries, Руководство пользователя

Страница: 66 / 160

52
IBM xSeries 342: User’s Reference
Installing a non-hot-swap drive
Before you install drives in your server, verify that you have all the cables and any
other equipment specified in the documentation that comes with the internal drive.
You might also need to perform certain pre-installation activities. Some of the steps
are required only during the initial installation of an option.
Note: The illustrations in this document might differ slightly from your hardware.
To install a non-hot-swap drive:
1. Review the information in “Before you begin” on page 35, in “Safety information”
on page 37, and “Handling static-sensitive devices” on page 36.
2. Turn off the server and peripheral devices, and then remove the cover and bezel.
(See “Removing the cover and bezel” on page 43.)
3. Remove the filler panel from the bay opening by pushing in the side latches and
pulling the filler panel away from the server. You do not need the filler panel when
you have a drive installed in the bay.
Note: The electromagnetic interference (EMI) integrity and cooling of the server
are protected by having the non-hot-swap bays covered or occupied.
When you install a drive, save the filler panel from the bay, in case you
later remove the drive and do not replace it with another.
Slide rails
Side latches
Slide rail
Slide rail
Drive