IBM eServer 342 xSeries, Руководство пользователя

Страница: 61 / 160

Chapter 5. Installing Options
47
9. Install the adapter:
a. Carefully grasp the adapter by its top edge or upper corners, and align it with
the expansion slot on the system board.
b. Press the adapter firmly into the expansion slot.
Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector before you
apply power. Incomplete insertion might cause damage to the system board
or the adapter.
c. Insert and tighten the expansion-slot screw on the top of the adapter bracket.
10. Connect any needed cables to the adapter.
• If you are installing a ServeRAID adapter, disconnect the cable from SCSI
connector A (J24) on the system board and plug it into the connector on the
top of the ServeRAID adapter. See “System board internal cable connectors”
on page 29 for the location of SCSI connector A.
The following illustration shows the rerouting of the SCSI cable if you install a
ServeRAID adapter.
• If you are installing an adapter that is not a ServeRAID adapter, refer to the
documentation that came with your adapter for cabling instructions.
Attention: Route cables so that the flow of air from the fans is not blocked. In
addition, route any cables plugged into the PCI adapter under adjacent adapters
so they are not pinched between the top of the adapter and the top cover.
11. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 66.
SCSI
connector A (J24)