IBM eServer 342 xSeries, Руководство пользователя

Страница: 59 / 160

Chapter 5. Installing Options
45
PCI slots 2-5, and then the system board SCSI channels A and B, if you have not
changed the boot precedence from the default.
You can use the Configuration/Setup Utility program to change the boot
precedence for your server. Select
Start Options from the Configuration/Setup
Utility program main menu.
• The optional IBM Remote Supervisor Adapter must be installed in PCI slot 1 only.
The ribbon cable that ships with the adapter is required to connect the adapter to
the system board. The external power adapter that ships with the adapter is not
required with this server.
Installing an adapter
Refer to the following illustration to install an adapter.
Note: The illustrations in this document might differ slightly from your hardware.
To install an adapter:
1. Review the information in “Before you begin” on page 35, in “Safety information”
on page 37, and “Handling static-sensitive devices” on page 36.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the cover (see “Removing the cover and bezel” on
page 43).
3. Determine which expansion slot you will use for the adapter.
Attention: Check the instructions that come with the adapter for any
requirements or restrictions.
4. Remove the expansion-slot cover:
a. Loosen and remove the screw on the top of the expansion-slot cover.
Adapter
Expansion-slot cover