IBM 865951Y - Netfinity 5000 - 51Y, Руководство по техническому обслуживанию аппаратной части

Страница: 134 / 220

Preparing a tower model:
The hard disk drives in
the Netfinity 5000 are hot-swappable. If you are installing
only a hard disk drive (bays 1 through 5), go directly to
“Internal drives installation or removing” on page 113.
Otherwise, continue with the following steps.
1. If you have a modem or fax machine attached to the
server, disconnect the telephone line from the wall
outlet and the server.
Note
If you are in the United Kingdom, you must
perform this step before disconnecting the power
cord.
Caution
The Power-on switch on the front of the server
does not turn off the electrical current supplied to
the server. The server also might have more
than one power cord. To remove all electrical
current from the server, ensure that all power
cords are disconnected from the power source.
2. Unplug all power cords (cables) from electrical
outlets, and then disconnect all other cables from the
back of the server.
3. Open the server door, if you have not already done
so.
4. Remove the left-side cover.
a. Locate the cover-release lever on the front of the
server and slide it to the right.
Cover
Release
Lever
b. Slide the left-side cover back about 25 mm (1
inch); then, lift the cover and remove it.
c. Store the cover in a safe place.
126
Netfinity Server HMM