IBM 865951Y - Netfinity 5000 - 51Y, Руководство по техническому обслуживанию аппаратной части

Страница: 47 / 220

pnt0-12 Device failed checksum test!
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the PCI Ethernet device type is set to the default
(enabled) position in the Configuration/Setup utility programs (see “PCI bus
control” on page 30). If the Ethernet adapter is enabled, go to “Diagnostic test
programs” on page 10 to run the diagnostic utility.
pnt0-13 add_intr_handler failed! Interrupts already enabled.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server.
Action: Modify the hardware settings.
Run the NETCONFIG program to match the hardware settings.
pnt0-14 Cannot locate hardware.
Explanation: The SunSoft Solaris driver cannot find any Ethernet controller.
Action: Verify that the PCI Ethernet device type is set to the default
(enabled) position in the Configuration/Setup utility programs (see “PCI bus
control” on page 30). If the Ethernet adapter is enabled, go to “Diagnostic test
programs” on page 10 to run the diagnostic utility.
pnt0-15 No more devices to open.
Explanation: The SunSoft Solaris driver cannot find any more Ethernet
controllers.
Action: Verify that additional Ethernet adapters are present or replace the
Ethernet adapter that fails to respond. If the problem persists, go to
“Diagnostic test programs” on page 10 to run the diagnostic utility.
pnt0-17 Device fault...Reset initiated!
Explanation: The SunSoft Solaris driver has been reset due to a device
fault.
Action: Verify that additional Ethernet adapters are present or replace the
Ethernet adapter that fails to respond. If the problem persists, go to
“Diagnostic test programs” on page 10 to run the diagnostic utility.
pnt0-19 IRQ found for PCnet hardware does not match space.c
(or pnt.conf)!
Explanation: This is a warning message referring to the interrupt request
(IRQ) that the SunSoft Solaris driver found in the system.
Action: Ignore this message if you are sure that this is what you want to do.
Otherwise, run the NETCONFIG program to match the hardware settings.
pnt0-20 add_intr_handler failed! Unknown interrupt type.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server.
Action: Modify the hardware settings.
Run the NETCONFIG program to search for another Ethernet controller.
pnt0-21 add_intr_handler failed! Out of range interrupt number.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server.
Action: Modify the hardware settings.
Run the NETCONFIG program to search for another Ethernet controller.
pnt0-22 add_intr_handler failed! Out of range IPL.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server.
Action: Modify the hardware settings.
Run the NETCONFIG program to search for another Ethernet controller.
Netfinity 5000 - Type 8659
39