IBM 8639 - PC Server 325, Руководство по техническому обслуживанию аппаратной части

Страница: 95 / 145

Power Switch: Use this switch to power the
server on manually, or return the server to
standby
mode. The automatic restart feature, which
enables the server to restart following a
momentary power loss, means that the server is
never completely powered-off. Do not set the
server to standby mode if any of the drive In-Use
lights are on. This might damage the information
stored on a hard disk or diskette.
You can configure the server to start at a specified
date and time, or when it receives a signal from
either serial port.
The result of pressing the power switch varies,
depending on whether the server is in attended,
unattended, or standby mode.
Ÿ
To power-on the server from standby mode,
press and release the power switch.
Ÿ
To power-off the server when in unattended
mode, press the power switch in slowly just
until the power-on light goes out and then
immediately release the switch.
Ÿ
To power-off unattended mode but leave the
server on, press and release the power
switch.
Ÿ
To turn unattended mode and return to
standby mode, press the power switch just
until the power LEDs go out.
90
PC Server HMM