IBM 8639 - PC Server 325, Руководство по техническому обслуживанию аппаратной части

Страница: 73 / 145

Password
If a power-on password or administration password is set,
you must type the password and press Enter before POST
will continue.
Note
If an administration password is set and then
forgotten, it cannot be overridden or removed. You
must replace the system board.
If a power-on password is set and forgotten, you can
regain access to the server by using either of the following
methods:
Ÿ
Entering the administration password at the power-on
prompt. Start the Configuration/Setup Utility
programs and change the power-on password.
Ÿ
Changing the position of the power-on password
jumper (J12). See “System Board” on page 103.
When you restart the server, POST proceeds without
prompting for the password for this startup only. Start
the Configuration/Setup Utilities programs and set a
new power-on password. Leave the power-on
password jumper (J12) in its new position, unless you
need to perform this procedure again.
Alarm/Wakeup Settings:
For proper operation of the Alarm/Wakeup Settings
options, set the Password Prompt choice to Off. See
“Configuration/Setup Utility Program” on page 33.
Set the Wakeup features immediately before you plan to
Power-off the server. The server locks and cannot be
used after you exit, saving settings. When the server
restarts, in either Attended or Unattended mode, the
Wakeup features return to the default, disabled settings.
When both Wakeup features are enabled, the server starts
when the first event (time or signal) occurs.
68
PC Server HMM