IBM 8639 - PC Server 325, Руководство по техническому обслуживанию аппаратной части

Страница: 64 / 145

Packet Driver Messages:
This section contains the error messages for the packet
driver. The explanation and recommended action are
included with each message.
PCNTPK-DOS-1 The command syntax is PCNTPK [-n]
[-d] [-w]
<
INT=packet_int_no
>
[IRQ=int_no] [IOADDR=io_addr]
[DMA=dma_no] [BUSTYPE=bus]
[DMAROTATE] [TP] [LED0=xx]
[BUSTYPE=bus] [LED0=xx]
[LED2=xx] [LED3=xx]
Explanation: The driver command was not entered
correctly.
Action: If you entered the command from the command
line, enter the command with the correct syntax. If the
command is in the AUTOEXEC.NET file, edit the file to
correct the syntax. The only parameters that should be
included are PCNTPK and BUSTYPE=PCI1.
PCNTPK-DOS-2 Unable to reset the PCnet device.
Explanation: The software could not reset the Ethernet
controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run
the diagnostic utility.
PCNTPK-DOS-3 Unable to initialize the PCnet device.
Explanation: The software could not initialize the
Ethernet controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Check the interrupt settings in the Configuration/Setup
utility programs. For more information, go to “PCI
Bus Control” on page 34.
3. If the problem persists, go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run
the diagnostic utility.
PC Server 325 - Type 8639
59