IBM 8639 - PC Server 325, Руководство по техническому обслуживанию аппаратной части

Страница: 61 / 145

PCNTNW-DOS-24 WARNING: PCNET IRQ doesn't
match protocol.ini.
Explanation: The IRQ setting in PROTOCOL.INI does
not match the hardware IRQ setting.
Action: Remove the IRQ setting from PROTOCOL.INI or
match the IRQ setting in PROTOCOL.INI with the
hardware jumper setting.
PCNTNW-DOS-25 PCI scan specified, PCI bus not
found!
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Go to “General Checkout/Diagnostics QAPlus/PRO”
on page 1 to run the diagnostic utility.
PCNTNW-DOS-29 WARNING: DMA number is not
necessary for PCI device.
Explanation: The Ethernet controller does not require a
DMA setting.
Action: Remove the DMA setting in PROTOCOL.INI.
PCNTNW-DOS-32 IRQ number is already in use by
another PCNET device.
Explanation: The specified IRQ number is already in use
by another Ethernet controller or device.
Action: Modify the IRQ setting in the PROTOCOL.INI file,
or modify the IRQ settings in the Configuration/Setup utility
programs. See “PCI Bus Control” on page 34 for
information on setting the interrupt requests in the
Configuration/Setup utility programs.
PCNTNW-DOS-33 PCNET device with specified
IOBASE is already in use.
Explanation: The specified IO address number is already
in use by another Ethernet controller or device.
Action: Modify the IO address setting on the hardware,
or modify the IO address setting in the PROTOCOL.INI
file.
56
PC Server HMM