IBM 8639 - PC Server 325, Руководство по техническому обслуживанию аппаратной части

Страница: 65 / 145

PCNTPK-DOS-5 There is already a packet driver at
xxxx.
Explanation: The driver is already loaded at this memory
location. It cannot be loaded a second time at the same
location.
Action: Do not reload the driver. If you want to load the
driver at a different memory location, specify another
software interrupt address on the INT parameter.
PCNTPK-DOS-6
<
IRQ=int_no
>
should be between 0
and 15 inclusive.
Explanation: The specified IRQ is out of range for the
Ethernet controller.
Action: Use valid IRQ values.
PCNTPK-DOS-7 Packet driver failed to initialize the
board.
Explanation: The board initialization failed.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Go to “General Checkout/Diagnostics QAPlus/PRO”
on page 1 to run the diagnostic utility.
PCNTPK-DOS-8
<
INT
=
packet_int_no
>
should be in the
range 0x60 to 0x80.
Explanation: The specified software interrupt number is
out of the allowable range.
Action: Specify a valid value for the INT parameter.
PCNTPK-DOS-12 PCI device IRQ number mismatch.
Explanation: The specified IRQ number does not match
with the IRQ number assigned by the PCI BIOS.
Action: Remove the IRQ setting.
PCNTPK-15 The device was not found.
Explanation: The driver cannot find an Ethernet
controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run
the diagnostic utility.
60
PC Server HMM