HP AE370A - Brocade 4Gb SAN Switch 4/12, Руководство администратора

Страница: 79 / 447

Fabric OS 5.2.x administrator guide 79
The recovery string must be between 8 and 40 alphanumeric characters. A random string that is 15
characters or longer is recommended for higher security. The firmware only prompts for this password
once. It is not necessary to remember the recovery string because it is displayed the next time you enter
the command shell.
The following prompt displays:
7. Enter the boot PROM password; then reenter it when prompted. The password must be eight
alphanumeric characters (any additional characters are not recorded). Record this password for future
use.
The new password is automatically saved (the
saveEnv
command is not required).
8. Connect to the active CP blade by serial or telnet and enter the
haEnable
command to restore high
availability; then fail over the active CP blade by entering the
haFailover
command.
Traffic flow through the active CP blade resumes when the failover is complete.
9. Connect the serial cable to the serial port on the new standby CP blade (previously the active
CP blade).
10. Repeat step 2 through step 7 for the new standby CP blade (each CP blade has a separate boot PROM
password).
11. Connect to the active CP blade by serial or telnet and enter the
haEnable
command to restore high
availability.
How to set the boot PROM password for a Director without a recovery string
Although you can set the boot PROM password without also setting the recovery string, it is strongly
recommended that you set both the password and the string as described in ” Without a Recovery String ”
on page 114. If your site procedures dictate that you must set the boot PROM password without the string,
follow the procedure that applies to your switch model.
NOTE: Setting the boot PROM password requires accessing the boot prompt, which stops traffic flow
through the switch until the switch is rebooted. You should perform this procedure during a planned down
time.
4/8 and 4/16 SAN Switch, SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32, SAN
Switch 4/32, 4/64 SAN Switch, and 400 MP Router
How to set the boot PROM password for a switch without a recovery string
1.
Create a serial connection to the switch as described in ” How to connect via the serial port ” on
page 24.
2. Reboot the switch by entering the
reboot
command.
3.
Press ESC within four seconds after the message “Press escape within 4 seconds...” displays.
The following options are available:
4.
Enter 3 .
5. At the shell prompt, enter the
passwd
command.
New password:
Option Description
1 Start system. Continues the system boot process.
2 Recovery password. Lets you set the recovery string and the boot PROM
password.
3 Enter command shell. Provides access to boot parameters.