HP AE370A - Brocade 4Gb SAN Switch 4/12, Руководство администратора

Страница: 169 / 447

Fabric OS 5.2.x administrator guide 169
Message
The command failed due to presence of long-distance ports in LS mode. Please remove these settings before
proceeding.
Probable Cause and Recommended Action
The firmware download operation was attempting to downgrade a system to Fabric OS v5.0.0 or lower
with long-distance ports in LS mode. Long-distance ports in LS mode is not supported in firmware v5.0.0 or
lower, so the firmware download operation failed.
Change the long distance port setting to a supported distance setting using the
portCfgLongDistance
command (the numerical value representing each distance level is shown in parentheses), and then retry
the firmware download operation. The supported settings are described briefly below:
L0 (0) Specify L0 to configure the port to be a regular switch port. A total of 20 full-size
frame buffers are reserved for data traffic, regardless of the port’s operating speed;
therefore, the maximum supported link distance is 10 km, 5 km, or 2.5 km for the
port at speeds of 1 Gbit/sec, 2 Gbit/sec, or 4 Gbit/sec respectively.
L0.5 (4) Specify L0.5 (
portCfgShow
displays the two-letter code as LM) long distance, up to
25 km. A total of 12, 25, or 50 full-size frame buffers are reserved for data traffic for
the port at speeds of 1 Gbit/sec, 2 Gbit/sec, or 4 Gbit/sec respectively.
L1 (1) Specify L1 long distance to support a long distance link up to 50 km. A total of 25,
50, or 100 full-size frame buffers are reserved for data traffic for the port at speeds of
1 Gbit/sec, 2 Gbit/sec, or 4 Gbit/sec respectively.
L2 (2) Specify L2 long distance to support a long distance link up to 100 km. A total of 50,
100, or 200 full-size frame buffers are reserved for data traffic for the port at speeds
of 1 Gbit/sec, 2 Gbit/sec, or 4 Gbit/sec respectively. For previously released
switches (Bloom1-based), the number of frames buffers is limited to 63.
LE (3) Specify LE mode is for E_Ports for distances beyond 5 Km and up to 10 Km. A total
of 5, 10, or 20 full-size frame buffers are reserved for port speeds of 1 Gbit/sec, 2
Gbit/sec, or 4 Gbit/sec, respectively. LE does not require an Extended Fabrics
license.
LD (5) Specify LD for automatic long-distance configuration. The buffer credits for the given
E_Port are automatically configured, based on the actual link distance. Up to a total
of 250 full-size frame buffers are reserved, depending upon the distance measured
during E_Port initialization. If the desired distance is provided, it is used as the upper
limit to the measured distance. For Bloom1-based systems, the number of frame
buffers is limited to 63.
LS (6) Specify LS mode to configure a long-distance link with a fixed buffer allocation. Up
to a total of 250 full-size frame buffers are reserved for data traffic, depending on the
desired distance value provided with the
portCfgLongDistance
command. For
Bloom1-based systems, the number of frame buffers is limited to 63.