164
mpls rsvp-te hello-lost
Description
Use the
mpls rsvp-te hello-lost
command to configure the maximum number of consecutive hello losses
before an RSVP neighbor is considered dead.
Use the
undo mpls rsvp-te hello-lost
command to restore the default.
By default, the RSVP node considers an RSVP neighbor is dead if no response is received after sending
three consecutive hellos.
An RSVP node detects whether its RSVP neighbor is still alive by sending hellos regularly. If no response is
received after the number of consecutive hellos reaches the specified limit, the RSVP node considers its
RSVP neighbor as dead. The failure is handled the same as a link layer communication failure.
Before configuring this command, be sure to enable RSVP-TE and enable RSVP hello extension in MPLS
view.
Related commands:
mpls rsvp-te timer hello
.
Syntax
mpls rsvp-te hello-lost
times
undo mpls rsvp-te hello-lost
View
MPLS view
Default level
2: System level
Parameters
times
: Specifies the maximum number of consecutive hello losses before an RSVP neighbor is considered
dead, ranging from 3 to 10.
Examples
# Set the maximum number of consecutive hello losses before an RSVP neighbor is considered dead to
five.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls rsvp-te hello-lost 5
mpls rsvp-te keep-multiplier
Description
Use the
mpls rsvp-te keep-multiplier
command to configure the keep multiplier for the PSB and RSB.
Use the
undo mpls rsvp-te keep-multiplier
command to restore default.
The default keep multiplier is 3.
The following equation determines the timeout time of the state stored in PSB and RSB:
Expired_Time = (
keep-multiplier
+ 0.5) × 1.5 ×
refresh-time
refresh-time
is the refresh interval for reservation state set by the
mpls rsvp-te timer refresh
command.
