Honeywell HPM, Сервисная инструкция

Страница: 438 / 498

7 IOP Calibration Procedures
7.4 LLAI IOP Calibration Procedure
438 HPM High-Performance Process Manager Service R688
Honeywell December 2020
Calibration procedure
To calibrate, perform the following steps.
Step Action
1
Each LLAI IOP card and FTA has been calibrated at the factory for all input types. If
recalibration must be performed in the field, power must be applied to the LLAI for at
least 30 minutes for temperature stabilization before starting the calibration. The
calibration procedure calibrates all channels on one FTA simultaneously, rather than
each channel singularly. Have the operator place the IOP card in an
Idle state using the
HPM Detail Status display.
2
If the FTA has screw terminal strips, temporarily remove the plastic cover. Remove the
field wiring from the FTA and substitute "zero input" sources for all channels. These
inputs are short copper wire jumpers across the input terminals. Refer to Figure 208
Zero Calibration Circuit
– TC and All Linear Zero Circuits and Figure 209 Zero
Calibration Circuit
– RTD ZeroCu: 10 Ohm, Pt: 100 Ohm, Ni: 120 Ohm as appropriate.
Figure 208 Zero Calibration Circuit
– TC and All Linear Zero Circuits
NC A
B
C
A
B
C
Shield
Channels 2 through 8
NC
Shield
NC
Connects to referenc e
junc tion s ensor on FTA
Channel 1
1
2
3
4
TB1
17
TB2
Referenc e
Model MU/MC-TAIL01 and MU/MC-TAIL02 FTAs
Model MU/MC-TAIL03 FTA
NC
A
B
C
Channels 1 through 8
NC Shield
1 3
Install the jumper bet ween pins 2 and 3
to connec t the referenc e junction
sens or to c hannel 1.
2
P1
2481- A