Hioki 8860-50, Инструкция по эксплуатации

Страница: 238 / 490

8.14 Searching a Waveform
226
Operating Key Procedure
Setting Logic Channel Search Criteria
10
Select the criteria number to use.
CURSOR
F1 to F8 Move the cursor to the [No.] item.
Select a number for this set of search criteria,
from Analog 1 to Analog 8.
11
Select the timebase to search (if measured using two
timebases).
CURSOR
F1 to F8 Move the cursor to the [Axis] item.
Select either choice.
12
Select the trigger search criteria for logic channels
Set the trigger search criteria for each channel.
To combine different search criteria with logical [AND] or [OR],
repeat steps 10 to 12 to specify all necessary criteria.
Search
13
CURSOR
F1
Move the cursor to the [Exec] button.
Starts searching.
[Searching] appears on the Status bar, and the
locations where search criteria are satisfied are
displayed.
Search markers (
indicate locations where
search criteria are met.
To search for more instances
F2 Select [Next] .
To move a cursor to a found location
F4
or
F5
Select [Move Cur A] or [Move Cur B] .
To insert an event mark at a location where search
criteria are met.
CURSOR
F6
Move the cursor to the [Mark] button.
Select [Mark].
14
Close the search function.
F8 Select [Close] .
11
10
12
Logic channel
search criteria
Trigger filter (Filter Width)
Trigger pattern
13 14
Timebase 1
Searches a Timebase 1 channel (de-
fault setting).
Timebase 2 Searches a Timebase 2 channel.
S
Trigger search criteria settings are made
using the same procedures as the pre-
measurement trigger criteria settings.
See "6.8 Triggering by Logic Signals
(Logic Trigger)" (p. 159)
Select ( ) [Auto Close] to
have the dialog close auto-
matically after searching.