hilscher NANL-B500G-RE, Руководство пользователя

Страница: 22 / 90

Description 22/90
3.2 Interactive and Autonomous operating mode
Figure 4: Interactive and Autonomous operating mode
Interactive operating mode
In the "Interactive operating mode" the NANL-B500G-RE device is
connected to a PC.
Autonomous operating mode
The NANL-B500G-RE device allows you (starting with the netANALYZER
firmware image version 1.2.0.0) to additionally use the "Autonomous
operating mode", in which the device is not connected to a PC. In this
operating mode, you can integrate the analyzer device into a
communication link and start and stop the recording of frames by pressing
the button (red REC key). The data is stored directly on the connected USB
memory device.
·
In the "Autonomous operating mode" usable "Live dump mode" the
NANL-B500G-RE analyzer device stores all recorded data traffic
directly on a connected USB memory device.
· The "Snapshot mode" that can be used in the "Autonomous operating
mode" is suitable for long-term measurements. The analyzer device
NANL B500G-RE uses the decoding capabilities of netANALYZER
Scope available in the "Autonomous operating mode". A trigger criterion
is defined using netANALYZER Scope. Each time the trigger criterion
occurs, the NANL B500G-RE analyzer device stores an Ethernet frame
snapshot of a short period of time before or after the trigger time on the
USB memory device. The snapshots can then be conveniently opened
and analyzed in netANALYZER Scope.
Important:
Further descriptions for the use of the analyzer device NANL-
B500G-RE in the Interactive operating mode as well as the
Autonomous operating mode can be found in chapter
Commissioning [
}
page 35].
netANALYZER device NANL-B500G-RE | Installation, operation and hardware description
DOC091110UM26EN | Revision 26 | English | 2019-07 | Released | Public © Hilscher 2007-2019