hilscher NANL-B500G-RE, Руководство пользователя

Страница: 84 / 90

Technical data 84/90
NANL-B500G-RE Parameters Value
Diagnosis interface USB interface for
autonomous operating mode USB socket (type A, 4-pin)
The USB socket provides a maximum of 500 mA, sufficient
for the connection of an USB stick. When connecting an
USB hard disk, a separate power supply is required.
USB memroy device for
autonomous operating mode USB stick or USB hard drive, USB 2.0, FAT32 formatted,
at least 100 Mbyte memory capacity
·
The write rate on the USB memory device depends on
the type of USB memory device.
· In the "Autonomous Mode" if the network is loaded with
very high network loads greater than 25% (bidirectional
or 50% unidirectional), not all frame data can be
captured when capturing on one TAP. These details
refer to permanent average loads. Short load peaks can
also be higher.
·
In "Snapshot mode", the use of hardware filters can help
to reduce the amount of data if necessary. In "Snapshot
mode", the performance depends on the number of
configured variables and the complexity of the trigger
condition, since the processing of the frames in the
trigger and during the decoding of the variables requires
computation time.
External
I/O interface External Interface Input Signals/
Output Signals (female
connector):
4 digital inputs/outputs ( GPIO s 0 to 3), 3.3 V / 1 mA or 24V /
600 mA (refer to section Maximum permissible current
consumption (external IO Interface) [
}
page 24]);
Minimum distance for GPIO events > 150 µs
Displays LED Display (at the front side of
the devices) SYS System status
STA0 Capturing active / inactive
STA1 Event signal detected
I/O Indicates the GPIO status (3.3V input, 24V
input, 3,3V output, 24V output)
LED yellow Ethernet RX status ( each at RJ45Ch0
and RJ45Ch1 )
LED green Ethernet Link status
Refer to chapter LEDs [ } page 75]. Descriptions of the LED
flashing codes in the autonomous operating mode, see
section
SYS, STA0, STA1, I/O, LINK and RX (Front
side) [
}
page 75].
LED display (at the reverse side
of the devices)
Indicates whether the recorded
data is transmitted secure from
loss to the PC.
LED green/
orange Ethernet LINK 1000
LINK 100 status ( to Gigabit Ethernet
RJ45 socket )
LED green Ethernet LINK ACT
status
Refer to chapter LEDs [
}
page 75].
Power supply Supply voltage nominal 24V DC / 700 mA / 16.8 W (refer to sections Power Supply
and Host Interface and
Power Supply NANL-B500G-
RE [
}
page 79])
Range of the operating voltage 18V ... 30V DC
Connector 24V voltage supply Combicon 0V/+24V/FE: Voltage supply 24V DC, ±6V,
Pin 1 = GND; Pin 2 = +24V; Pin 3 = FE; Maximum
permitted cable length: 3 m
Alternatively Female Con24 V: Voltage supply 24V
DC, ±6V max. 3 A, External = GND, Pin = +24V; for barrel
plug: (ø 5,5 / ø 2,1) L = 12 mm;
Maximum permitted cable length: 3 m
Power switch ON / OFF
netANALYZER device NANL-B500G-RE | Installation, operation and hardware description
DOC091110UM26EN | Revision 26 | English | 2019-07 | Released | Public © Hilscher 2007-2019