Getting started
32/90
5.5
Configure IP address
Note:
The IP address of the device and the IP address of the PC must be
in the same network respectively the
The NANL-B500G-RE device can operate in three different modes:
·
Static IP address (
manual assignment
)
A fixed IP address is assigned to the analyzer device NANL-B500G-RE.
The user must manually assign the IP address designated.
·
mode (
external DHCP server required
)
The IP address is assigned to the analyzer device NANL-B500G-RE.
The device gets an IP address from the external DHCP server using the
DHCP protocol. This IP address then automatically is assigned.
·
device operates as DHCP server
)
As a DHCP server, the analyzer device NANL-B500G-RE assigns itself
IP addresses to other devices.
This option is the default setting in the most common use case. The
user must not make any configuration.
Important:
The analyzer device NANL-B500G-RE must not be inserted via a
switch or hub directly into a corporate network with other devices.
Otherwise, it may lead to wrong assignment of IP addresses and
malfunction. The analyzer device works by default as an external
DHCP server in the
DHCP server operation mode
independently
and assigns IP addresses to other devices. This may happen also
to devices which are not concerned by the netANALYZER
measurements.
For the data captured by the analyzer device NANL-B500G-RE and
transmitted over an Ethernet connection to the PC arrive safely, you
may use the analyzer device exclusively with a laptop or a PC with
a separate network card.
DHCP server operation
Therefore you must set your LAN connection to (IP V4)
Automatically
obtain IP address
.
netANALYZER device NANL-B500G-RE | Installation, operation and hardware description
DOC091110UM26EN | Revision 26 | English | 2019-07 | Released | Public
© Hilscher 2007-2019
