Hardware Installation and Uninstalling
74/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
6.3 Fix Front Plate Sticker
6.3.1
Fix Front Plate Sticker at CIFX 50-RE, CIFX 50-RE\ET, CIFX 50E-
RE and CIFX 50E-RE\ET
Note:
Your PC card cifX set contains a set of front plate stickers (9 different stickers).
Depending from the loaded firmware the label on each sticker indicates for the respective
system the following
LED names
:
- of the
system and communication status LEDs
(
above
)
- of the
RJ45 Ethernet female connector LEDs
(
below
).
Further information to this question you find also in chapter
LED Descriptions
beginning
from page 80.
Electrostatically sensitive Devices
"
To prevent damage to the PC and the PC card cifX, make sure, that the
PC card cifX is grounded via the endplate and the PC and make sure,
that you are discharged when you install/uninstall the PC card cifX.
"
Use the sticker according to the device and firmware and glue it on the
front of the PC card CIFX 50-RE, CIFX 50-RE\ET, CIFX 50E-RE or
CIFX 50E-RE\ET.
Figure 46: Front Plate Stickers for CIFX 50-RE, CIFX 50-RE\ET, CIFX 50E-RE or CIFX
50E-RE\ET
LED
Ether
C
A
T
Master
Ether
C
A
T
Slave
E
ther
N
et/IP
Open
Modb
us/T
CP
PO
WE
RLI
NK
P
R
OFI
N
ET IO
sercos Master
sercos Slav
e
VA
R
AN
SYS
(yellow/green)
SYS SYS SYS SYS SYS SYS SYS SYS SYS
COM 0 (red/ green)
RUN
RUN
MS RUN
BS SF STA S RUN
COM 1 (red/ green)
ERR
ERR
NS ERR
BE BF ERR - ERR
green
LINK
L/A IN
LINK
LINK L/A LINK L/A L/A LINK
RJ45
Ch0
yellow
ACT
-
ACT
ACT
-
RX/TX
-
-
ACT
green LINK
L/A
OUT
LINK
LINK L/A LINK L/A L/A LINK
RJ45
Ch1
yellow
ACT
- ACT
ACT
- RX/TX
- - ACT
Table 28: LED Labeling depending of the loaded Firmware
