Technical Data
133/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
10.1.12 CIFX 50-2DP\CO
CIFX 50-2DP\CO
Parameter
Value
Name CIFX
50-2DP\CO
Part No.
1252.470
Description
PC Card cifX PCI 2 channel -
Channel X0: PROFIBUS DP Master or Slave,
Channel X1: CANopen Master or Slave
Part
Function
Communication interface with PCI, 1 x PROFIBUS and
1 x CANopen interface
Communication
Controller
Type netX
100
processor
RAM
8 MB SDRAM
FLASH
4 MB serial Flash EPROM
Integrated Memory
Size of the Dual-Port Memory
64 KByte
Bus Type
PCI, according to [bus spec 1], refer to section
Overview
,
page 114.
Transmission Rate
33 MHz
Data Access
DPM or DMA (Direct Memory Access)
System Interface
Width for the data access to the
Dual-Port Memory (DPM)
32-Bit
PROFIBUS
Communication
Supported communication
standard/ protocol (determined by
the loaded firmware)
PROFIBUS DP Master,
PROFIBUS DP Slave
Transmission rate
9,6 kBit/s, 19,2 kBit/s, 31,25 kBit/s, 45,45 kBit/s, 93,75
kBit/s, 187,5 kBit/s, 500 kBit/s, 1,5 MBit/s, 3 MBit/s,
6 MBit/s, 12 MBit/s
Interface Type
2 * RS 485, refer to section
PROFIBUS Interface
p. 107.
Galvanic Isolation
isolated
Isolation Voltage
1000 VDC (tested for 1 minute)
PROFIBUS Interface
Connector
DSub female Connector, 9 pin
CANopen
Communication
Supported communication
standard/ protocol (determined by
the loaded firmware)
CANopen Master,
CANopen Slave
Transmission rate
10 kBit/s, 20 kBit/s, 50 kBit/s, 100 kBit/s, 125 kBit/s,
250 kBit/s, 500 kBit/s, 800 kBit/s, 1 MBit/s
Interface Type
ISO-11898, refer to section
CANopen Interface
, page 107.
Galvanic Isolation
optically isolated
Isolation Voltage
1000 VDC (tested for 1 minute)
CANopen Interface
Connector
DSub male Connector, 9 pin
SYS
System Status LED
COM 0
LED Communication Status 0 (duo LED) for
channel X1
CAN 1
CANopen Status 1 (duo LED) for channel X2
Display LED
Display
The meaning of the LEDs COM0 and CAN1 depends on
the loaded firmware. Refer to chapter
LED Descriptions
,
page 80.
Supply Voltage
+3.3 V dc ±5 %, refer to section
Power Supply and Host
Interface
, page 34.
Maximum Current at 3.3 V
(typically)
700 mA
Power supply
Connector
Via PCI Bus
Operation
Rotary Switch Slot Number
(Card ID)
To set the Slot Number (Card ID)
