Technical Data
147/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
CIFX 100EH-RE
Parameter
Value
Master and Slave
Configuration Software Slave
netX Configuration Tool
Table 114: Technical Data CIFX 100EH-RE\CUBE
10.1.21 CIFX 70E-DP, CIFX 70E-DP\MR
CIFX 70E-DP,
CIFX 70E-DP\MR
Parameter
Value
Name
CIFX 70E-DP
CIFX 70E-DP\MR
Part No.
1259.410
1259.413
Description
PC Card cifX Low Profile PCI Express PROFIBUS DP
Master or Slave and PROFIBUS MPI Device (Low Profile
PCIe with PROFIBUS), (and variants with additional
MRAM ‚MR’)
Part
Function
Communication interface with PCI Express and
PROFIBUS interface
Communication
Controller
Type netX
100
processor
RAM
8 MB SDRAM
FLASH
4 MB serial Flash EPROM
Size of the Dual-Port Memory
64 KByte
Integrated Memory
MRAM (only CIFX 70E-DP\MR)
128Kbyte (= 64K Words);
Note:
Using the cifX Device Driver (from Version 1.1.1.0)
access to this memory is possible and it can be used as a
remanent memory.
Bus Type
PCI Express, One Lane Port, according to [bus spec 2,
Rev. 2.0] and [bus spec 3], refer to section
Overview
,
page 114.
Transmission Rate
2 GBit/s
Data Access
DPM or DMA (Direct Memory Access)
System Interface
Width for the data access to the
Dual-Port Memory (DPM)
32-Bit
PROFIBUS
Communication
Supported communication
standard/ protocol (determined by
the loaded firmware)
PROFIBUS DP Master,
PROFIBUS DP Slave,
PROFIBUS MPI Device
Transmission rate
9,6 kBit/s, 19,2 kBit/s, 31,25 kBit/s, 45,45 kBit/s,
93,75 kBit/s, 187,5 kBit/s, 500 kBit/s, 1,5 MBit/s,
3 MBit/s, 6 MBit/s, 12 MBit/s
Interface Type
RS 485, refer to section
PROFIBUS Interface
, page 107.
Galvanic Isolation
isolated
Isolation Voltage
1000 VDC (tested for 1 minute)
PROFIBUS Interface
Connector
DSub female Connector, 9 pin
SYS
System Status LED
COM
LED Communication Status (duo LED)
Display LED
Display
The meaning of the COM LED depends on the loaded
firmware. Refer to chapter
LED Descriptions
, page 80.
Supply Voltage
+3.3 V dc ±5 %, refer to section
Power Supply and Host
Interface
, page 34.
Maximum Current at 3.3 V
(typically)
800 mA
Power supply
Connector
Via PCI Express Bus
Operation
Rotary Switch Slot Number
To set the Slot Number (Card ID)
