Technical Data
116/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
10 Technical Data
10.1 Technical Data PC Cards cifX
Note:
All technical data are temporarily and can be altered without notice.
10.1.1 CIFX 50-RE, CIFX 50-RE\ET
CIFX 50-RE,
CIFX 50-RE\ET
Parameter
Value
Name
CIFX 50-RE
CIFX 50-RE\ET
Part No.
1250.100
1250.105
Description
PC Card cifX PCI Real-Time Ethernet Master or Slave
Part
Function
Communication interface with PCI and Ethernet interface
Communication
Controller
Type netX
500
processor
RAM
8 MB SDRAM
FLASH
4 MB serial Flash EPROM
Integrated Memory
Size of the Dual-Port Memory
64 KByte
Bus Type
PCI, according to [bus spec 1], refer to section
Overview
,
page 114.
Transmission Rate
33 MHz
Data Access
DPM or DMA (Direct Memory Access)
System Interface
Width for the data access to the
Dual-Port Memory (DPM)
32-Bit
EtherCAT Master, EtherCAT Slave
EtherNet/IP Scanner (Master),
EtherNet/IP Adapter (Slave),
Open Modbus/TCP
POWERLINK Controlled Node/Slave
PROFINET IO-Controller (Master),
PROFINET IO-Device (Slave)
sercos Master, sercos Slave
Supported Real-Time Ethernet
communication systems
(determined by the loaded
firmware)
VARAN Client (Slave)
Ethernet
Communication
Ethernet Frame Types
Ethernet II
Transmission rate
100 MBit/s, 10 MBit/s (depending on loaded firmware)
Interface Type
100 BASE-TX,
10 BASE-T (depending on loaded firmware),
refer to section
Ethernet Interface
, page 105.
Galvanic Isolation
isolated
Isolation Voltage
1000 VDC (tested for 1 minute)
Half duplex/Full duplex
depending on loaded firmware,
supported (at 100 MBit/s)
Auto-Negotiation
depending on loaded firmware
Auto-Crossover
depending on loaded firmware
Connector
2* RJ45 Socket
Ethernet Interface
Channel 0 and 1
With loaded EtherCAT Master firmware only the RJ45
channel 0 can be used, channel 1 is deactivated.
Beginning with the EtherCAT Master firmware version 3
channel 1 can be reactivated if redundancy is activated.
For Open Modbus/TCP with V2.3.4.0 and higher both