Hettich 9 257 300, Инструкция по эксплуатации и сборке

Страница: 20 / 144

20
5. Software
(4) User interface navigation
In the User interface navigation columns, the buttons shown
below let you navigate to other user interfaces. The relevant page
is displayed as soon as a button is greyed out (see User Interface
navigation table).
User interface navigation
Screen selection button Explanation
The Main menu interface is
now being displayed.
(cannot be used)
Selects main menu
(can be used)
Selects last screen or last level
(can be used)
Selects screen last selected or
last level
(cannot be used)
Screen selection button Explanation
Selects first screen
Service
(can be used)
Selects first screen
Service
(cannot be used)
Screen selection button Explanation
Selects servo screen or selects
first screen showing overview
of a station's servo drives
(can be used)
Selects servo screen or selects
first screen showing overview
of a station's servo drives
(cannot be used)
5.2.2 "Main Menu" user interface
The Main menu page is the highest level in the operating struc-
ture.
This displays information on the machine's current status. The
following pages describe the function of the controls as well as
the other user interfaces in greater detail.
Fig. 12: "Main menu"
The main menu lets you enter either the nominal drawer dimensi-
ons or the actual width of the drawer base. Pressing the relevant
button activates the mode you wish to use. The mode activated is
indicated by a green coloured button.
Entering a permissible numerical value lets you set width adjust-
ment to the appropriate width by means of two hand control.
On selecting the nominal size, a distinction can also be made bet-
ween type 16 and 19. Depending on the size selected, the width
adjustment facility moves to the nominal dimensions that will
be used. Pressing any of the input fields opens a keypad window.
This is where you can enter the numerical value and confirm it by
pressing Enter.
After reaching the end position (see button animation) the pro-
duction process can be started after inserting the components.
en