Hettich 9 257 300, Инструкция по эксплуатации и сборке

Страница: 36 / 144

36
10. Troubleshooting
10.1 Malfunctions and troubleshooting
Initially, troubleshooting or fault finding is carried out:
• by the operator
• then by the line supervisor (e.g. foreman)
• then by servicing personnel.
Notify the manufacturer's customer service department if neces-
sary.
10.2 Troubleshooting
1. Eliminate the fault source so that work can be restarted
without any hitch when the machine is restarted.
2. Remove faulty components from the machine.
3. Replace faulty components with new ones.
10.3 Switching ON and malfunction message
If a malfunction message also appears on the display after the
machine has been properly switched on, perform the following
steps:
1. Carry out visual machine inspection.
2. Select "home position" on the operator panel.
Once the malfunction message on the operator panel is closed,
you can start assembling drawers.
If it does not, please contact Hettich Customer Service (see page
2).
Note
Information on malfunctions affecting the soft-
ware is provided in the "Software" section.
i
Machine malfunctions must only be rectified by qualified staff.
When identifying the source of malfunction, attention must be
paid to the entire area surrounding the machine.
Immediately notify the manufacturer of any damage occurring
during the warranty period.
Malfunctions are displayed on the operator panel.
In case of a fault, you can try and return the machine to the
home position.
The malfunction message on the operator panel is cleared as
soon as the malfunction has been rectified. If it does not, please
contact Hettich Customer Service.
Hettich Customer Service
Phone: +49 5223 7 1765
E-mail: HPH-service@de.hettich.com
Note
Observe safety regulations while identifying the
source of malfunction and rectifying malfunc-
tion!
Observe the accident prevention regulations!
i
Note
Please note that modifications and/or repairs
may only be carried out by the service personnel
from
Paul Hettich GmbH & Co. KG
.
Unauthorised changes to the machine will result
in the loss of product liability and liability on the
part of the manufacturer for resultant damage.
i
en