Hagie 204SP, Руководство оператора, Страница: 94 / 127

SECTION 8 –
MAINTENANCE AND STORAGE
8-17
6. Repeat the same sequence to 150
dry ft.-lbs., and again to 180 dry ft.-lbs.
NOTE: If the wheel turns during lug nut
torquing, lower machine to the
ground - just enough for the tire to
touch and prevent rotation. Or, more
preferably, place a suitable wedge
between the tire and the ground.
Lower the machine and resume
operation. Recheck torque after 30
minutes of operation.
7. When torquing is complete, lubricate
exposed threads with anti-seize com-
pound.
Leg Mounting Bolts
NOTE: Check Leg Mounting Bolt torque
daily.
To torque leg mounting bolts:
1. Start lug nuts on the mounting bolts and
tighten until snug.
2. Following the torque sequence (as
shown in the following illustration), turn
each lug nut to a value of 100 dry ft.-lbs.
NOTE: Use slow, even pressure on the
torque wrench. Quick or jerky
movements can cause inaccurate
values.
3. Lower machine to the ground and repeat
same sequence to 130 dry ft.-lbs., and
again to 160 dry ft.-lbs.
4. Resume operation and recheck torque
values after 30 minutes.
SERVICE - TOE-IN
Toe-In Adjustment
NOTE: Toe should be set with the machine
in the “run” position and the air bags
set.
To adjust Toe-In of the front tires, perform
the following for both front steering cylinders:
1. Remove Cotter Pin, Castle Nut, and
Lock Washer from the steering cylinder
assembly.
CAUTION
Never remove more than three leg
mounting bolts from any single leg
mount.
Torque Sequence
6
1
3
4
2
5