Hagie 204SP, Руководство оператора, Страница: 113 / 127

9-12
SECTION 9 –
MISCELLANEOUS
4. Check sensor installation by turning the
ignition key to the ON position. DO NOT
start the engine.
5. Attach the Depth Command Actuator to
the Light Sensor Mount and Tool Bar.
Quad Puller Assembly
NOTE: Some Quad Pullers may come pre-
assembled to the tool bar.
NOTE: Refer to your Parts Manual for
specific hardware used.
1. Install two (2) Quad Pullers on each lift
head tube, as shown.
2. Ensure each Quad Puller measures 16”
(40.6 cm) from the outside of the mount
head to the outside of the quad puller
mounting tube, making adjustments as
necessary.
NOTE: Distance may vary depending on
planting pattern.
3. Using a 3/4” socket, tighten each Quad
Puller Bolt (two on each Quad Puller
Mounting Tube).
4. Install two Stalk Guides onto each Quad
Puller, positioned as shown.
• Install four (4) Stalk Guide Bolts (2 each side)
through the front side of each Stalk Guide/Quad
Puller.
• Install four (4) Stalk Guide Nuts (2 each side)
onto the bolts and tighten with a 7/16” socket.
NOTICE
Over-tightening of the Sensor Arm Pivot
Bolt may cause the actuator to stall.
NOTICE
Ensure quad puller tires have equal
pressure. Check tire pressure daily.
CAUTION
RISK OF INJURY FROM ROTATING TIRES.
DO NOT PLACE FINGERS OR HAND NEAR
MOVING QUAD PULLER TIRES, DISLODGE A
WEDGED OBJECT FROM MOVING TIRES, OR
PERFORM MAINTENANCE NEAR MOVING TIRES.
Quad Puller
-Typical View
• Lift Head
Tube
• Measure 16” (40.6 cm) from the outside of the
mount head to the outside of the quad puller
mounting tube
16”
Quad Puller Bolts
(Located on each
Quad Puller Mounting Tube)
-Typical View