Gigamon GigaVUE TA Series, Руководство по установке оборудования

Страница: 64 / 108

64 GigaVUE TA Series Hardware Installation Guide
GigaVUE-TA200
On the GigaVUE-TA200, only the first 32 out of 64 100Gb ports are enabled.
A port license is available to enable an additional 32 ports to expand from 32
ports to 64 ports.
Enabling Additional Ports
Contact your Sales Representative for information on obtaining a license key.
Once you have obtained the license key for additional ports on
GigaVUE-TA10A, GigaVUE-TA100, or GigaVUE-TA200, use the following
command:
(config) # license install box-id <box ID> key <license key>
where:
• box ID is the box ID of the GigaVUE TA Series node
• license key is the license key obtained for the purposes of enabling
additional ports
Use the following procedure to enable ports before starting to issue
commands in the CLI:
1.
Connect to the console port as described in the previous section.
2.
Wait at least two minutes after the system prompt appears for the system
to be initialized and then switch to
Configure mode.
The GigaVUE TA Series node provides three command entry modes,
each with increasingly powerful rights –
Standard , Enable , and
Configure . The jump-start script is only available in Configure mode:
a.
Type en <Enter> to switch to Enable mode.
The system prompt changes from [hostname] > to [hostname] # .
b.
Type config t <Enter> to switch to Config mode.
The system prompt changes from [hostname] # to [hostname]
(config) # .
3.
Reset the terminal settings to match the current window with the following
command:
terminal resize
4.
Use the port command with the admin argument to enable ports. For
example, the following two commands enable all available ports on a fully
licensed GigaVUE-TA10A:
(config) # port 1/1/q1..q4 params admin enable
(config) # port 1/1/x24..x48 params admin enable
5.
Save your changes so that ports come up automatically at the next
reboot:
write memory