Gigamon GigaVUE TA Series, Руководство по установке оборудования

Страница: 58 / 108

58 GigaVUE TA Series Hardware Installation Guide
Configuring Basic Settings
This section describes how to perform the initial configuration of basic
settings over a serial terminal connection to the console port.
The system administrator must initially log in with a default admin account
using a default password, and then must immediately change the password
through the
jump-start script. Refer to Access the Command-Line Interface
over the console Port on page 58 .
Once you have used the console port to configure the Mgmt port’s network
properties, you can configure the GigaVUE TA Series node remotely using
the Mgmt port’s network connection.
N
OTE
:
The same commands are available in the command-line interface
regardless of how you connect.
Access the Command-Line Interface over the console Port
1.
Make the basic power and console cable connections described in
Connecting Serial Console and Mgmt Ports on page 57 and power on the
GigaVUE TA Series node.
2.
Start a terminal application on the PC. Common terminal applications
include TeraTerm, PuTTY, and Hyperterminal.
3.
Select the COM port connected to the console cable attached to the
console port. For example,
COM1 .
4.
Configure the port settings for the console connection as follows:
• Bits per second – 115,200
• Data bits – 8
• Parity – None
• Stop bits – 1
• Flow control – None
N
OTE
:
On the GigaVUE-TA10 and GigaVUE-TA40, you can change the
console port’s speed if you need to by using the procedure in Changing
the Console Port’s Speed on page 60 .
If you experience problems connecting to a Cisco Terminal Server, try
changing the console Port’s speed to 9600 bps using the procedure in
Changing the Console Port’s Speed on page 60 and reconnecting.
N
OTE
:
The GigaVUE-TA100, GigaVUE-TA100-CXP, and GigaVUE-TA200
support only a fixed serial baud rate of 115,200bps.