Gigamon GigaVUE TA Series, Руководство по установке оборудования

Страница: 62 / 108

62 GigaVUE TA Series Hardware Installation Guide
5.
Review your settings. You can change a setting by specifying its listed line
number and re-entering the setting.
6.
When you are satisfied with your settings, exit the script as prompted.
The system automatically saves your settings.
7.
Restart the system with the reload command.
Need to Change Any Settings?
If you need to change any of the settings you made in the jump-start script,
you can either run the script again or change individual settings using the
following commands in the Configure command mode:
• Use the hostname command to change the system’s hostname.
• Use the interface eth0 command to reconfigure or fine-tune Mgmt port
settings, including basic IP settings (DHCP or static address and subnet
mask) and physical parameters (duplex, MTU, and speed).
• Use the ip command to change the default gateway, DNS server, and
domain name.
• You can also use the username admin password <password>
command to change the admin user’s password. Refer to Changing the
admin Account Password on page 75 .
Refer to Completing the Initial Setup on page 72 for a quick summary of the
available GigaVUE commands for TA Series nodes.
Cluster Enable? Enable cluster support if this node will be a
part of a cluster of connected GigaVUE
nodes. If you enable cluster support, the
jump-start script prompts you to supply the
Cluster ID , Cluster Name , and Cluster
Mgmt Virtual IP Address . You can join an
existing cluster by supplying values that
match existing settings.
If clustering is enabled, you will not be
prompted for a box ID in the next step.
Refer to the GigaVUE-OS CLI Reference
Guide for information on setting up a cluster.
N
OTE
:
Connecting a Traffic Aggregator to
a cluster requires a license.
Box ID for the Node Supply a numerical box ID for the node. This
box ID is used to identify network/tool ports
in the node – the format is box ID/ slot ID/
port ID.
You will be prompted for a box ID only if
clustering was not enabled in the previous
step.