Gigamon GigaVUE TA Series, Руководство по установке оборудования

Страница: 18 / 108

18 GigaVUE TA Series Hardware Installation Guide
Introducing the GigaVUE-TA100 Chassis
This section describes the physical layout of the GigaVUE-TA100 chassis, including a
description of all ports and connectors. The GigaVUE-TA100 chassis consists of a
1RU, rack-mountable, 19”-wide chassis with management, network, and tool ports at
the front and power connections and fans at the rear.
Figure 1-3 shows the ports at the
front of the GigaVUE-TA100 chassis. Refer to Table 1-3 for a description of each of the
ports. Figure 1-4 shows the fan modules and power supply units at the rear of the
GigaVUE-TA100 chassis. Refer to Chassis Cooling on page 20 for information on fans
and temperature monitoring.
The GigaVUE-TA100 provides thirty-two ports, supporting high-density aggregation.
Depending on the transceiver, QSFP+ or QSFP28, the ports run at speeds of either
40Gb or 100Gb. With QSFP+ transceivers, a 40Gb port can be broken out into four
10Gb ports, called
4x10G mode.
The 100Gb/40Gb ports on GigaVUE-TA100 can be used as network, tool, hybrid, or
stack-link ports.
The GigaVUE-TA100 node in standalone mode must be running software version
4.6.01 or higher. The GigaVUE-TA100 node in a cluster environment must be running
software version 4.8 or higher.
Figure 1-3: The GigaVUE-TA100 Chassis Front View
100Gb QSFP28 Ports:
16 + 8 + 8 = 32
Port Status LEDs
100Gb Ports
GigaVUE-TA100 Traffic Aggregator includes 32 100Gb ports (C1..C32).
In a cluster configuration, these ports can either be set as network ports or as stack-link ports.
Console Port
Use the console port for serial terminal connections to the GigaVUE CLI. Unless
you requested custom factory settings, the serial settings are 8N1, 115,200 bps.
Management Port
Standard 10/100/1000 RJ45 Ethernet ports support remote connections to the
GigaVUE CLI using Telnet/SSH.
Green LED shows link status; amber LED shows activity.
This port is also used in a cluster configuration to manage cluster traffic.
LEDs: PWR, SYSTEM, and FAN
USB Port
GigaVUE-TA100 Front View
Console and Mgmt Ports
100Gb/40Gb Ports
The 100Gb ports can operate at 40Gb with QSFP+
transceivers.
You can configure a port mode that let a QSFP+
transceiver (40Gb port) operate as four logical 10Gb ports.
Once configured, cable a 40Gb port operating as four 10Gb
ports to an optical patch panel or breakout panel, which
takes a 40Gb QSFP+ input from the GigaVUE-TA100 and
splits it to four independent 10Gb output ports.