Gigamon GigaVUE TA Series, Руководство по установке оборудования

Страница: 52 / 108

52 GigaVUE TA Series Hardware Installation Guide
Grounding the GigaVUE TA Series Chassis
1.
Locate the grounding holes at the rear of the chassis. Refer to Figure 4-1
or Figure 4-2 .
Figure 4-1: Ground Screws (GigaVUE-TA10 Shown)
Figure 4-2: Ground Screws (GigaVUE-TA200 Shown)
2.
Install ground screws meeting the following specifications:
#8 Panhead, Phillips-drive, Exterior SEM screw
Thread size = 32
Length = 1/2in (1.27cm)
3.
Connect grounding wire with spade lugs both to the ground screws and to
earth ground. The specifications for the ground wire and lugs are as
follows:
Standard Wire 14 (AWG); Stud Size #6 (0.138in/0.351cm); Spade Width 0.32in/0.813cm
4.
Tighten the screws to secure both the chassis ground screws and the
earth ground screws.
The GigaVUE TA Series chassis is drilled for ground
screws at the rear of the chassis. Connect grounding
wire with spade lugs to the ground screws on the
chassis and earth ground using the following
procedure.
Equipment Ground Equipment Ground
Equipment Ground