General DataComm SC-ADT 16 Por, Руководство по установке и эксплуатации

Страница: 39 / 106

076R172-000 SpectraComm ADT 3-1
Issue 6 Installation and Operation Manual
Chapter 3:
SC-ADT Configuration
Configuration Overview
SC-ADT configuration is performed through the command line interface (CLI). You can execute
CLI commands at a HyperTerminal connection or through a Telnet connection. A brief overview
of CLI is provided below. For a detailed guide to Smart CLI, refer to
Appendix A, Application
Guidelines . The web-based CLI is described in Chapter 4, The Web Interface .
The SC-ADT command line interface is an interactive means of configuring the SC-ADT through
a Telnet session over the LAN or by typing commands at a VT100-compatible ACSII terminal
connected to the SC-ADT
CRAFT
port. The CLI is a smart, controlled-access interface that
provides general and context-sensitive help, automatically expands abbreviated command or
subcommands and also anticipates any required command arguments. The CLI will prompt for any
required argument that is missing from a command line.
Smart CLI Quick Reference
• Get context-sensitive command help by using the
?
character in the CLI command string.
• Type
?
at the command prompt to view a description of IP and Utility commands (shown
below). If you are in User mode, some commands shown below will not display.
ADT-16%> ?
______________________System Commands____________________________________
clear Reset functions
configure Configure system parameters
connect Connect to terminal port or modem
default Default configuration to factory values.
disable Turn off supervisor/admin commands
enable Turn on supervisor/admin commands
help Description of the command line interface and help system
ping Send ping to remote device
show Show system parameters
telnet TELNET to remote device
trace-rte Trace route packets take to remote device
_______________________Utility Commands___________________________________
batch Store and/or run commands in batch mode
chat Start/Answer chat session with another ADT CLI user
contact Turn contact on or off
diags Set/Show port loopback state
exit Exit Command Line Interface
find-alert Find port alert string by port
flash Copy flash files/select flash boot file
reboot Halt and perform a reboot
netstat Show TCP socket connections
services Show/Enable/Disable HTTP, SNMP, TELNET, SSH, TFTP & FTP Services
syslog Send SYSLOG msg to server
who-am-i Show current user nam
• Execute each command string by pressing the
Enter
key (or <
cr
>).
• Commands entered in the proper syntax and with all required parameters/arguments will take
effect immediately. If required parameters or arguments are missing from the command string,
you will be prompted for them individually.
• Abbreviated commands are accepted at the command prompt.
• To configure IP and subnet mask addresses, refer to Appendix A, Application Guidelines .