General DataComm SC-ADT 16 Por, Руководство по установке и эксплуатации

Страница: 70 / 106

Additional Features Authentication Protocol
5-2 SpectraComm ADT 076R172-000
Installation and Operation Manual Issue 6
Authentication Protocol
In addition to local authentication where the usernames and passwords reside on each individual
SC-ADT device, SC-ADT can be configured for authentication. This capability
supports the CISCO protocol for authentication between the SC-ADT device and the
server. When is enabled, the server becomes the central point
for managing network-wide usernames and passwords. This is especially useful when provisioning
SC-ADT devices in large networks.
usernames and passwords are authenticated for all access methods: craft, Telnet, and
HTTP. You must be logged in with ADMIN privileges to access SC-ADT’s commands.
Detailed information and configuration procedures are provided in the paragraphs below.
• For help in setting parameters, type:
configure ?
• To show the status of , type:
show
Figure 5-1 Help and Status Displays for
----------------------------------------------------------------
Authentication is disabled.
Console Authentication is disabled.
Server IP:
default key:
default timeout: 5
max attempts: 3
admin username: $gdc_adt_admin$
supv username: $gdc_adt_supervisor$
en -pass state: disabled
fallback state: enabled
banner:
local banner:
----------------------------------------------------------------
___________Help for "configure "______________________________
account Accounting enable/disable (not supported yet)
authen Authentication enable/disable
author Authorization enable/disable (not supported yet)
attempts Set max number of attempts to login; requires 1 parameter(s)
banner Optional message when starting /local authentication
console Enable/Disable console user authentication
admin Define username for Admin password; requires 1 parameter(s)
supv Define username for Supervisor password; requires 1 parameter(s)
en-pass Allow use of Server IP address
fallback Enable/Disablefallback to local authentication
server Specify Server IP address
key Set default encription key; requires 1 parameter(s)
timeout Default timeout for Server to reply; requires 1 parameter(s)
testing Authentication testing