GE PhastSystem, Руководство пользователя

Страница: 58 / 106

58
7. Press ”9" and ”do”.
8. Press ”step forward”. Leave these values set to 1.0.
DEV 9 Ct(5,30,40,50)°C = (1.0,1.0,1.0,1.0)
9. Press ”step forward”. Leave the alarm instruction blank.
EXTRA ALARM TO SOUND AT 9.00 t=00.0min
10. Press ”step forward” for the first method step.
In steps 1 through 9, program the in-port (IN = 0) to
correspond to the step number, for example, IN = 1, IN = 2,
IN = 3, for steps 1, 2, and 3, respectively. Leave the out-port
and the temperature T, set to zero. Set the time t, to 0.1 minute
for each step.
DEV 9.01 IN = 1 OUT = 0 t=00.lmin T=00°C
The out-port will always empty to waste (port 0). The chamber
will empty immediately after it fills.
Running the cleaning method
1. Remove the cap set from the ports.
2. Cut the PVC tubing into 10 lengths, one for each port.
3. Lead the tubes into a bottle containing at least 700 ml of
distilled or de-ionized water.
4. Lead tube 0 to waste; use an empty bottle for waste.
5. Open the lid of the development chamber by pressing on the
right end of the red bar.
6. Check that the lid gasket is secure.
7. Insert the level sensor shield into the upper position of the gel
holder, if it is not already there.
Important! The level sensor shield must remain in the
chamber when running methods without gels;
otherwise, the level sensor will be splashed by
incoming solution, causing it to give a false signal
that the chamber is full.
8. Close the lid and lock it simultaneously pressing on the lid and
pressing in the red bar.
9. Press ”DEV start/stop” and enter the method number, for
example, ”9”.
START DEV 9.00 (CLEANING) <do>
10. Press ”do” to start the run.
Before using solutions other than water to clean the unit, check the
chemical resistance of the wetted parts to the chemical(s) you plan to
use. See chapter 3, Description of the system, for more information
about the chemical resistance of the wetted parts in the development
unit.
5. Operation