GE GA000100, Руководство по обслуживанию

Страница: 618 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 284 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-10 Video Jumper (Flex) replacement
The Video Jumper (Flex) is used in VIVID E9 with 2D and without DVR.
The jumper is included in the BEP6.X Cable Kit - Spare Part , Part Number 5433408-80.
8-11-10-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the
Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the
Left Side Cover .
5.) Remove the BEP Cover .
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP .
c.) Set the BEP Cover aside.
6.)
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
8-11-10-2 Video Jumper (Flex) removal
Follow these steps to remove the Video Jumper (Flex) :
1.) Flip the retainer levers on the side of the connectors CN DV11 and CN DV12 to the side.
2.) Unplug and remove the Video Jumper (Flex) .
8-11-10-3 Video Jumper (Flex) installation
Follow these steps to install the Video Jumper (Flex) :
1.) Connect the two connectors on the Video Jumper (Flex) to CN DV11 and CN DV12 (on the BEP’s
motherboard).
2.) Install the BEP Cover .
3.) Install the Left Side Cover .