GE GA000100, Руководство по обслуживанию

Страница: 593 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 259
8-11-3-3 BEP6 Hard Disk Drive (HDD) installation procedure
1.) Position the HDD Assembly so it enters the two guides and slide the HDD in. You may need to apply
a pressure to make it slide into position.
2.) Install the two screws that secures the HDD Bracket to the BEP’s frame.
3.) Connect the two HDD cables to the HDD.
4.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
5.) Replace the Left Side Cover.
6.) Connect the Mains Power Cable to the wall outlet.
7.) Power up the VIVID E9.
8.) Install the System software and the Application software.
9.) Enter the VIVID E9’s TCPIP settings and Option strings.
10.)Restore the Patient Archive images, Report Archive, User-Defined Configuration (Customer
Presets), and Service settings.
11.)Continue with 8-11-3-6 "Calibration and adjustments" on page 8-261 .
NOTICE
Be careful not to pinch any of the cables when installing the BEP Cover.