GE GA000100, Руководство по обслуживанию

Страница: 619 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 285
8-11-11 DVI to Samtec Jumper (Flex) replacement
The DVI to Samtec Jumper (Flex) is included in the BEP6.X Cable Kit - Spare Part,
Part Number 5433408-80.
8-11-11-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the
BEP Cover .
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP .
c.) Set the BEP Cover aside.
6.)
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
8-11-11-2 DVI to Samtec Jumper (Flex) removal
The number of cables in use, depends on the configuration:
• 4D with DVR: one cable is used.
• 4D without DVR: one cable is used.
• 2D with DVR: two cables are used.
• 2D without DVR does not use this cable.
Follow these steps to remove the DVI to Samtec Jumper (Flex) :
1.) Disconnect the cable from CN DV12 (on the motherboard).
2.) Repeat the step above for the second cable, if installed.