2 - 2
INP-TN4PHAV-E
(6)
Power supply switch
Used to turn on and off the power.
(7)
Keying operation section
This is used for setting various parameters, making checks and running the equipment.
FEED
LIST
DISPLAY
SELECT
ENTRY
RECORD
Name of key
Function
RECORD
Operation key for starting and stopping recording.
Recording starts when the key is pressed once and stops when the key is pressed again. This
key is ineffective during print-out of data or lists.
LIST
This is used for effecting print-out of data (instantaneous values).
If you wish to stop the print-out partway through, press the key again.
The recording paper fast feed key.
This key is always valid.
FEED
The speed is 3mm/sec during the first second that the key is held depressed and goes to
8mm/sec after the elapse of 1 second.
DISPLAY
1. This is used for changing the contents of displays. Successively pressing the key and
releasing it brings about the following 5 changeovers.
(1) Sequential display of the data of all channels.
However, there is no display for skip channels.
The data display is updated once every 3 seconds.
(2) Display only of the data of specific channels.
The data display is updated once every second.
(3) No 1 to 6 channels are display simultaneously, and data display is updated at 1 sec-
ond intervals.
(4) 7 - 12 channels are displayed simultaneously.
(This panel is not displayed when the number of recorded points is up to six.)
Data display is updated once every second.
(5) Display of the data and time.
2. This key is used for shifting from a set mode to the data display mode.
This key is ineffective during print-out of data or lists.
SELECT
1. Used for shifting from the data display mode to a set mode.
2. Is used for effecting sequential read-out of parameters during operation in a set mode.
This key is ineffective during print-out of data or lists.
ENTRY
Is used to register set data.
This key is effective only during set mode operation.
Used to scroll numerical values up and down.
(up) (down)
The values are scrolled up or down 1 count each time the relevant key is pressed. Holding a
key depressed for more than 0.5 seconds results in a fast up/down scroll at a rate of 5 counts/
second and holding it depressed for a further 2 seconds results in an ultra-fast scroll of 55
counts/second.
Special keying operations
Press
key
Used for reversing the recording paper feeding direction.
while pressing
(However, continuous feed is permitted up to about 25 mm.)
the FEED key.
