Foma SA702i, Руководство пользователя

Страница: 440 / 451

19
AT command list
・
The list below shows AT commands for FOMA SA702i Modem Port.
・
On the entry of AT commands, entered " = " may appear as "\", depending on the font setting
of the PC or communication software in use.
・
If the battery pack is removed from FOMA terminal before the terminal is powered off, the set
value may not be recorded.
AT command Overview Parameter/Description Command examples
AT%V Displays FOMA terminal
version.
Displays FOMA terminal version in
"VerX.XXX" format etc.
AT%V
Ver1.000
OK
AT&C<n> Sets the operating
conditions of the circuit
CD (DCD) for DTE.
＊ 1
n=0: Always ON.
n=1: Varies according to line
connection status (default).
When set to "&C1", the CD signal is
set to ON immediately before
sending "CONNECT" when ending
connection. The CD signal is set to
OFF immediately before the line is
disconnected and "NO CARRIER" is
sent.
AT&C1
OK
AT&D<n> Sets the operation
performed when circuit
ER (DTR) signal received
from DTE is switched from
ON to OFF under online
data mode.
＊ 1
n=0: Ignores status (always
regarded to be ON).
n=1: Moves to online command
mode when status changes
from ON to OFF.
n=2: Disconnects line and moves to
offline mode when status
changes from ON to OFF
(default).
AT&D1
OK
AT&E<n> Selects the type of speed
display used while
connecting.
＊
1
This command is valid only if
"ATX<n>" (
J
P25) is other than n=0.
n=0: Displays communication speed
of wireless zone.
n=1: Displays communication speed
between PC and FOMA
terminal (default).
AT&E1
OK
AT&F Resets the AT command
settings of FOMA terminal
to the factory default.
When this command is
entered during
communication, the
terminal is reset after the
line is disconnected.
AT&F
OK
AT&S<n> Sets how to control the
data set ready (DR) signal
to be output to DTE.
＊ 1
n=0: Always ON (default).
n=1: On when the line is connected.
AT&S0
OK
AT&W Registers the current
settings to FOMA terminal.
AT&W
OK
See next page