Fluke 5820A, Руководство оператора

Страница: 168 / 272

5820A
Operators Manual
6-26
Use multipliers e.g., k, M,
µ
with the OUT command, as desired.
Parameters: <value> V Volts dc or update volts ac
<value> DBM Volts ac dBm update (LEVSINE
mode only)
<value> V, <value> HZ Volts ac or volts dc with 0 Hz
<value> DBM, <value> HZ Volts ac in dBm
<value> HZ Update frequency
<value> S Pulse width
<value> S, <value> S Pulse width or update pulse width
<value> S, <value> HZ Pulse width or update period
<value> PCT Update percentage
<value> HZ, <value> S Period or update pulse width
<value> For single output, changes
amplitude keeping unit and
frequency the same.
<value>A Amps dc
<value>A, <value>HZ Amps ac
Examples:
VOLT, EDGE, LEVSINE, and WAVEGEN modes:
OUT 1.2 V, 1 kHZ output 1.2 V, 1 kHz
OUT 8 kHZ output 8 kHz, same amplitude as before
OUT 0 Hz output dc, same amplitude as before
OUT 1 V output 1 V, same frequency as before
(The frequencies have to differ for LEVSINE, its minimum being 50 kHz)
MARKER mode:
OUT 1 ms output 1 millisecond time marker
OUT 1 kHZ same thing
VIDEO mode:
OUT 100 pct output 100 % (1 V) video signal
OUT 1 V same thing
PULSE mode:
OUT 100 ns,1
µ
output 100 nanosecond width pulse, 1 microsecond period
OUT 100 ns,1MHz output 100 nanosecond width pulse, 1 microsecond period
OUT 100 ns output 100 nanosecond width pulse, same period as before
OUT 1 MHz output 1 microsecond period, same pulse width as before
OVERLD mode:
OUT 5 V output 5 V ac or dc signal, depending on RANGE selection
Each example shows a value and unit, e.g., -15.2 V. If a value is entered without a unit,
the value of the existing output is changed, when logically allowed.