![background image](http://html1.mh-extra.com/html/fendt/favorit-900/favorit-900_workshop-manual_4001870782.webp)
Farmer 400
Fav 700
Fav 900
Power lift / Electrohydraulic control EPC
Rear power lift - functional description
A
General
Fav 900 chassis number 23/3001 and up
29.11.2000
8610
000001
A
a
3/8
Capitel
Docu-No.
Index
Date
Version
Page
Rear power lift - functional description
c) Mechano-hydraulically
Bullet-List
●
Theoretical depth of power lift is determined by setpoint specification and regulated, i.e. adapted as
function of hybrid control system.
●
Lowering speed actually achieved, however, depends on implement weight and oil viscosity, i.e. it is
impossible to lower three-point linkage in EPC mode without implement and with cold oil.
Text-module
3. "EPC transport"
"EPC transport" setting is automatically reached when
Bullet-List
●
power lift has reached end position with "Lift = END" (detected by rear position sensor B030)
Explanation of functions:
a) Electrical
Bullet-List
●
Block multiway valve, consisting of AV3 and AV4, is in "EPC" position
●
This position is detected by solenoid switch S048 and transmitted to EPC box A005 pin 12, i.e. EPC
box is active.
●
Actual position is detected by rear power lift position sensor B030 and transmitted as voltage signal
to EPC box A005.
b) Hydraulically
Bullet-List
●
Without LS command and without active intervention of LS pump PR
●
Implement weight generates hydraulic counterpressure in lift cylinder.
●
Dynamic peak pressures while driving are brought under control by 230 bar pressure-relief valve in
EPC valve.
●
Leak-free integrity of system is ensured by integral control valve in "Lower" valve (i.e. with this EPC
valve fitted, no separate, hydraulically resettable non-return valve is needed any longer).
Text-module
4. "DA lift"
Text-module
5. "DA lower" (pressing downwards)
The "DA lift" and "DA lower" commands can only be activated by
Bullet-List
●
analogue setpoint command of second valve (normally "blue" at crossgate lever)
Explanation of functions:
General:
Bullet-List
●
For power lift DA function second control valve 1.2/Y016 with A and B connections (corresponding to
- and +) is used instead of EPC valve.
a) Electrical
Bullet-List
●
Block multiway valve, consisting of AV3 and AV4, is in "DA" position.
●
This position is detected by solenoid switch S048 and transmitted to EPC box A005 pin 12, i.e. EPC
box is no longer active in supplying power to control valve.
●
"Lift" or "Lower" command from external buttons (S027-S030) is transmitted from EPC box via K-bus
to ECU A002.
●
Set lift height limit at terminal is not active, and EPC end shutoff is also ignored.
Fav 700 single ECU
Bullet-List
●
The single ECU A002 is responsible for actuating the electrohydraulic control valves (and for the
transmission); the command for the valve comes via the transmission bus (=G-bus).
Bullet-List